|
|
Post by thomas8294 on Mar 18, 2021 14:23:40 GMT -8
Hello, I am looking for several parts to complete my 2nd Snark III and was looking for ideas! The parts truly needed are numbers 73 & 74 in Nemrods parts diagram. . . . .a set screw and locking nut. . . .additional parts I'd love to find would be a band clamp and new label. Any help would be greatly appreciated!
Tom
|
|
|
|
Post by scubalawyer on Mar 18, 2021 18:25:49 GMT -8
Hello, I am looking for several parts to complete my 2nd Snark III and was looking for ideas! The parts truly needed are numbers 73 & 74 in Nemrods parts diagram. . . . .a set screw and locking nut. . . .additional parts I'd love to find would be a band clamp and new label. Any help would be greatly appreciated! Tom
Allan might have a label. If not, he can make you one (might be a two label minimum) I forget.
|
|
|
|
Post by herman on Mar 19, 2021 2:46:32 GMT -8
Those (73/74) shouldn't be hard to find, they will be metric and SS but otherwise common. You could likely use a cap screw in place of the set screw. You may have to buy a number of them to get 1 (McMaster -100 SS nuts M3-2 for example is $5)but still not too bad. A good hardware store may have them as well.
|
|
|
|
Post by snark3 on Mar 19, 2021 8:43:25 GMT -8
As far as a band clamp goes I have several Snark 3's and I use USD band clamps on them, they work fine. You can get those from Bryan at Vintage double hose or Rob at the scuba museum.
|
|
