Need source for copper crush gaskets for valve rebuild

[scubalawyer]

Hello all,

Need assistance sourcing a supply of copper crush gaskets to go in some old Dacor tank valves I am putting back into service, I have tried the usual (McMaster-Carr, Amazon, E-Bay. Home Depo, etc...) but no luck. I know there are some valve rebuild kits out there but I don’t need all the extra stuff they come with - just the crush gasklets. I was able to fine one new one that a friend had and took the following exact measurements. Can't find any of this size. Any ideas on where to look?

ID:
13.38 mm
.527 in
67/128"

OD:
15.79 mm
.622 in
5/8"

Width:
1.27mm
.05 in
3/64"

Thickness:
.69mm
.027"
3/128"

Thanks in advance.

Mark

[vance]

Antique Diver (Bill T) is your man. If he doesn't have them, he'll know where. His email is listed in his profile.

[vance]

These are just soft copper washers w/o layers or the like?

[scubalawyer]

Thanks for the response. I located a commercial source through a friend on the VDH forum. As for Bill, I have his cell phone on speed dial and we speak every so often. Don't say I said so but Bill is Awesome!

M

[vance]

Why not say so? Bill T is the Man.

WTH?